WIRES. 4. After you are all done, make sure tie linkage, . Snap retaining clips in place. 7. Install center distributor wire. 8. After setting the point gap to specification with a feeler gauge as outlined above, check the dwell angle with a dwell meter. The dwell ... Start the engine, let it idle and reach operating temperature, and observe the dwell angle on the meter. The reading should fall within the allowable range given in the Tune-Up Specifications chart. ... RABBIT/ DASHER/SCIROCCO.
|Title||:||Chilton's basic auto maintenance|
|Author||:||Chilton Book Company. Automotive Editorial Dept|
|Publisher||:||Chilton Book Company - 1976-10-01|